Some things are very obvious such as non-original or reconed speakers, non-original transformers, replaced pots, re-tweed, re-tolex, re-grill, etc.and these changes are often disclosed and of a non-malicious nature. Will withstand high temperatures of pre-amp tubes, reusable when you change tubes. Contains two 8-pin sockets, two "bear trap" retainers, four mounting screws, two 470 ohm screen grid resistors (Metal-Film Flameproof for safety), and two carbon composition 1500 ohm control grid resistors. 1.19" in diameter, 0.86" tall (not including pins and center post). One year warranty, triple-diode construction for reliability and long service. Do not install in an amplifier that does not have a standby switch - always use the standby switch in amps so equipped when using the 5RTR. 90 capacitors total, each individually bagged by type and value. An economical alternative to more expensive tube dampers. Fender Vintage Amp (60s Blackface and 70s Silverface) Power Tube Socket replacement kit. ) from the original blackface and silverface eras which have two power tubes (6L6 or 6V6). Because there is no warm up of a rectifier tube when using this solid state device, it is absolutely necessary that a standby switch is used in conjunction with this device. Do not install in an amplifier that does not have a standby switch - always use the standby switch in amps so equipped when using the 5SSR. Contains 5 each of the following values in 630V Axial Metal Film (similar to Mallory 150 style): .001u F, .0022u F, .0047u F, .01u F, .022u F, .047u F, .1u F, .22u F, .47u F and 5 each of the following values in 630V polypropylene radial (similar to orange drop style): .001u F, .0022u F, .0047u F, .01u F, .022u F, .047u F, .1u F, .22u F, .47u F.
S.) and high power RF transmitters, as a display device in television sets and in microwave ovens.
This is a great kit to replaced all 6 of the tube shields in many Fender amps with 6 preamp tubes. Use two (or three) of these rings around a pre-amp tube to reduce noise and microphonics. 1.31" diameter, 0.89" tall (not including pins and center post). Because there is no warm up of a rectifier tube when using this solid state device, it is absolutely necessary that a standby switch is used in conjunction with this device.
By cleaning the remainder of the broken keyway from the tube base and properly installing this keyway replacement (a little dab of silicone sealant works great to hold it in place), your tube can safely be reinstalled into your equipment. Note: when using an adhesive to secure the keyway to the tube base, DO NOT use a water-based glue. Ruby Gold capacitors are used by many original amplifier manufactures in the Europe and the U. Ideal as replacement in vintage audio and guitar amplifiers.
We combined all of our information into a computerized database for this project and for the past 18 months have been slowly (sadly, very slowly) gathering information that we collect ourselves as well as from other people. What we need is the following: 1) Model name 2) Model number on the tube chart 3) Date code letters on the tube chart 4) Speaker codes (if speaker is original) 5) Transformer codes (if the amp doesn't have date codes on the tube chart) 6) Cosmetic features (flat/raised logo, tweed/tolex, blackface/silverface, rough/ smooth blond tolex, white/skirted knobs, TV-front/wide-panel, etc.) One very interesting and very important factoid has surfaced regarding the date code letters on the tube chart.
In the fall of 1965, Fender switched from stamping these numbers in black ink, to dark green ink.